2000 Mazda MPV DXFACTORY OEM SERVICE PROCEDURE

Component Locations

COMPONENT LOCATIONS

Component Location
Engine Coolant Temperature Sensor On Engine, Next To Coolant Filler Cap
Powertrain Control Module Mounted To Inner Firewall, Behind Glove Box & Air Duct
Pressure Control Solenoid (1)
Shift Solenoids "A", "B" & "C" (1)
Torque Converter Clutch Control Solenoid (1)
3-2 Timing Solenoid (1)
Input/Turbine Speed Sensor On Top End Of Transaxle
Vehicle Speed Sensor
With Anti-Lock Brake System (2)
Without Anti-Lock Brake System Mounted On Transaxle, Near Differential.
(1) On transaxle valve body. See Figure.
(2) Anti-lock brake wheel speed sensors are used for vehicle speed signal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.