2000 Mazda MPV DXFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Pre-Inspection

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the tire inflation, and adjust to the recommended pressure as necessary.
  2. Inspect the front wheel bearing play and correct as necessary. (See WHEEL BEARING PLAY .)
  3. Inspect the wheel and tire runouts. (See SUSPENSION TECHNICAL DATA [BP] .) (See SUSPENSION TECHNICAL DATA [BP WITH TC] .)
  4. Inspect the ball joints and steering linkage for excessive looseness.
  5. The vehicle must be on level ground and carry no luggage or passengers.
  6. Measure the height from the center of the wheel to the fender brim. The difference between the left and right measurement must not exceed 10 mm {0.39 in}. 
    Fig 1: Measuring Height From Center Of Wheel To Fender Brim
    G03638029Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.