2000 Mazda MPV DXFACTORY OEM SERVICE PROCEDURE

Cruise Control Switch Inspection

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION .)
  3. Disconnect the audio control switch connector. (See AUDIO CONTROL SWITCH REMOVAL/INSTALLATION .)
  4. Inspect for resistance and continuity between cruise control switch terminals B-C using a tester.
AUDIO CONTROL SWITCH SPECIFICATION

Switch condition Resistance (ohm)
ON/OFF button pressed Continuity
CANCEL button pressed 117-123
SET/COAST button pressed 666-694
RES/ACCEL button pressed 2,156-2,244
No button pressed No continuity
Fig 1: Identifying Audio Control Switch Terminal
G03702035Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.