2000 Mazda B2500 SX, AutomaticFACTORY OEM SERVICE PROCEDURE

Pinpoint Test 10: Radio Interference

PINPOINT TEST 10 - RADIO INTERFERENCE

PINPOINT TEST 10 RADIO INTERFERENCE
STEP  INSPECTION  ACTION 
1 VERIFY THERE IS RADIO INTERFERENCE
  • Start the engine.
  • Tune the radio to a station where the interference is present.
  • Key OFF.
  • Disconnect the generator connector A-168.
  • Start the engine.
  • Is the interference present with the generator disconnected? 
Yes Diagnose and repair audio system as necessary.
No Go to step 2.
2 SUBSTITUTE A KNOWN GOOD GENERATOR
  • Key OFF.
  • Install a known good generator.
  • Start the engine.
  • Is there radio interference present with a known good generator? 
Yes Install the original generator.
See GENERATOR in GENERATORS & REGULATORS article in Electrical

Diagnose and repair entertainment system as necessary.

No ACTION Replace the generator.
See GENERATOR in GENERATORS & REGULATORS article in Electrical .
.
Test the system for normal operation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.