Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mazda B2500 SX, AutomaticFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| Air Bag Diagnostic Monitor | Behind right side of dash. |
| Anti-Slosh Module | Integral with instrument cluster. |
| Central Timer Module (CTM) | Behind center of dash. |
| DRL Module (2.5L) | Left side of lower radiator support. See Figure . |
| DRL Module (3.0L) | Left side of lower radiator support. See Figure . |
| DRL Module (4.0L) | Left side of lower radiator support. See Figure . |
| Electric Shift Control Module | Behind center of dash. |
| Generic Electronic Module (GEM) | Behind center of dash. |
| Instrument Illumination Dimming Module | Behind left side of dash. |
| Passive Anti-Theft System (PATS) Module | Behind center of dash. |
| Passive Anti-Theft System (PATS) Transceiver Module | Behind left side of dash. |
| Powertrain Control Module (PCM) (2.5L) | Right rear of engine compartment, through firewall. See Figure . |
| Powertrain Control Module (PCM) (3.0L) | Right rear of engine compartment, through firewall. See Figure . |
| Powertrain Control Module (PCM) (4.0L) | Right rear of engine compartment, through firewall. See Figure . |
| Rear Anti-Lock Brake System (RABS) Module | Behind lower center of dash. |
| Remote Anti-Theft Personality (RAP) Module | Behind right kick panel. |
| 4-Wheel Anti-Lock Brake System (4WABS) Module (2.5L) | On left front inner fender panel. See Figure . |
| 4-Wheel Anti-Lock Brake System (4WABS) Module (3.0L) | On left front inner fender panel. See Figure . |
| 4-Wheel Anti-Lock Brake System (4WABS) Module (4.0L) | On left front inner fender panel. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.