2000 Mazda B2500 SX, AutomaticFACTORY OEM SERVICE PROCEDURE

Component Locations

WARNING: This page is about a different car, the 1999 Mazda B4000, 1999 Mazda B3000, and 1999 Mazda B2500. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT LOCATIONS

Component Location
Air Bag Diagnostic Monitor Behind Center Of Instrument Panel
Powertrain Control Module (PCM) On Right Center Of Firewall, In Engine Compartment
Power Distribution Box Left Rear Corner Of Engine Compartment
4WABS Left Of Engine Compartment, Near Battery
Harness Connector (X-134) Left Rear Of Engine Compartment
Harness Connector (X-136) Left Rear Of Engine Compartment
Harness Connector (X-179) Left Rear Of Engine Compartment
Harness Connector (X-201) Left Rear Of Engine Compartment
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.