2000 Mazda B2500 SX, AutomaticFACTORY OEM SERVICE PROCEDURE

Communication Network Diagnostics: Notes

WARNING: This page is about a different car, the 1999 Mazda B4000, 1999 Mazda B3000, and 1999 Mazda B2500. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Two-wheel drive vehicles without power windows and/or power door locks are equipped with a Central Timer Module (CTM). All other vehicles are equipped with a Generic Electronic Module (GEM). When diagnosing a network concern on vehicles equipped with a CTM, treat CTM as a GEM. NGS tester does not have a selection for CTM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.