2000 Mazda 626 ES, 2.0 C, AutomaticFACTORY OEM SERVICE PROCEDURE

OBD-II Drive Cycle Description

OBD-II drive cycle is a pattern of driving in which the PCM will execute all OBD-II diagnostic monitors. Drive cycle can be used to cause a DTC to set if a fault is present or to verify that a DTC will not return after a repair has been completed. If drive cycle is complete and P1000 is not cleared, repeat entire drive cycle.

NOTE: Rough road conditions may prevent certain steady state conditions and steady accelerations from validating the transmission and load related monitors.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.