2000 Mazda 626 ES, 2.0 C, AutomaticFACTORY OEM SERVICE PROCEDURE

HO2S/TWC Monitor Repair Verification Drive Cycle

Ensure vehicle engine coolant (ECT) PID is less than 170°F (76°C) and fuel level (FLI) PID is at least 15 percent. monitor period will start 5 minutes after engine is started. Connect scan tool. Warm engine to operating temperature 175-240°F (80-115°C). Drive vehicle at a steady speed above 30 MPH for at least 2 minutes. Stop vehicle. Using scan tool, check drive mode completion status. If test is not complete, turn ignition off. Repeat test from point after warm up. If test is complete, check test results. If results are okay, ensure no DTCs are present. If results are not okay, repairs are not complete.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.