1999 Mazda MX-5 Miata AutomaticFACTORY OEM SERVICE PROCEDURE

Connector Identification

Harness connector terminal identification illustrations are generic and categorized by number of terminals. For terminal identification of connectors with 1 or 2 terminals, see WIRING DIAGRAMS article. All connector views are terminal side unless otherwise specified. For harness connector terminal identification, see HARNESS CONNECTOR IDENTIFICATION DIRECTORY  .

HARNESS CONNECTOR IDENTIFICATION DIRECTORY

Description See Fig.
Miata 
Crankshaft Position Sensor 7
EGR Boost Sensor 7
EGR Valve 19
Fuel Pump 18
Fuel Tank Pressure Sensor 8
Front Heated Oxygen Sensor 9
Mass Air Flow Sensor 8
Powertrain Control Module (1) 15
Rear Heated Oxygen Sensor (2) 9
Rear Heated Oxygen Sensor (3) 10
Throttle Position Sensor 8
Millenia (2.3L) 
Camshaft Position Sensor 11
Crankshaft Position Sensor 8
EGR Valve Position Sensor 7
Fuel Gauge Sending Unit 7
Fuel Tank Pressure Sensor 7
Left Front Heated Oxygen Sensor 7
Left Rear Heated Oxygen Sensor 8
Intake Air Temperature Sensor 12
Manifold Absolute Pressure Sensor 7
Mass Air Flow Sensor 7
Powertrain Control Module (1) 16
Right Front Heated Oxygen Sensor 8
Right Rear Heated Oxygen Sensor 10
Throttle Position Sensor 11
Transmission Control Module (4) 17
Millenia (2.5L) 
Crankshaft Position Sensor 8
Distributor 12
EGR Boost Sensor 8
EGR Valve Position Sensor 7
Fuel Gauge Sending Unit 7
Fuel Tank Pressure Sensor 7
Left Front Heated Oxygen Sensor 10
Mass Air Flow Sensor 7
Middle Heated Oxygen Sensor 9
Powertrain Control Module (1) 16
Rear Heated Oxygen Sensor 9
Right Front Heated Oxygen Sensor 10
Throttle Position Sensor 11
(1) Component connector view.
(2) California emission models
(3) Except California emission models.
(4) Harness connector view.
Fig 1: Identifying 3-Pin Harness Connector
G97A06610Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.