Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Mazda MX-5 Miata AutomaticFACTORY OEM SERVICE PROCEDURE
Ignition Control Module (Millenia)
Testing information is not available from manufacturer. Check for diagnostic trouble codes. See appropriate SELF-DIAGNOSTICS article.
ECM/PCM TERMINAL IDENTIFICATION
| Wire Color To Ground (1) | KOEO Volts | KOER (Idle) Volts | ||||
|---|---|---|---|---|---|---|
| Miata | ||||||
| Brown/Yellow(3G) | Less Than 1 | .2 | ||||
| Brown (3H) | Less Than 1 | .2 | ||||
| Protege | ||||||
| 1.5L | ||||||
| Violet/Green (3A) | 0 Or 5 | 2 | ||||
| Yellow/Black (4N) | Less Than 1 | .3 | ||||
| 1.8L | ||||||
| Violet/Green (4F) | 0 Or 5 | 2 | ||||
| Yellow/Black (4N) | Less Than 1 | .3 | ||||
|
||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
