Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ignition Control Module
Check ignition coil, ECM/PCM and high-tension lead connections. Check secondary coil winding and high-tension lead resistance. Measure voltage between ground and appropriate ECM/PCM terminals. See ECM/PCM TERMINAL IDENTIFICATION table. If all measurements are within specification, and misfire still occurs, replace distributor or ignition coil.
| ECM/PCM Wire Color (1) | Closed Throttle Volts | WOT Volts | |||
|---|---|---|---|---|---|
| Protege 1.5L | |||||
| Violet/Green (3A) | 0 Or 5 | 2 | |||
| Yellow/Black (4N) | Less Than 1 | .3 | |||
|
|||||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.