Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Mazda MX-6 Base, StandardFACTORY OEM SERVICE PROCEDURE
Transaxle Disassembly
- Remove clutch release bearing and release fork. See Fig 1 or Fig 2 . Mount transaxle into holder. Remove rear cover. Secure primary shaft with Holder (49 F401 440). Shift to 1st or 2nd gear to lock rotation of primary shaft. Remove and discard lock nuts from primary and secondary shafts. Align ends of interlock sleeve and control lever. Turn shift rod counterclockwise. Remove sleeve, primary reverse synchronizer cone assembly, synchronizer ring.
- Remove 5th/reverse gear shift fork, 5th/reverse synchronizer hub assembly with synchronizer ring, 5th gear and gear sleeve from secondary shaft.
- Remove secondary 5th gear. Remove guide bolt from outside of case. Remove back-up light switch, neutral switch and lock bolt. Remove bolts securing transaxle case to converter housing. Using soft-faced hammer, strike case to loosen and remove.
- Remove reverse idler gear with shaft. Holding primary shaft assembly, secondary shaft assembly and shift forks as an assembly, lift and remove from clutch housing. Separate shift fork assemblies from shaft assemblies.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
