Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Mazda MX-6 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Circuit Testing
POWER WINDOW MAIN SWITCH CIRCUIT TEST
| Switch Position | Wire Color | |
|---|---|---|
| Driver's Switch | ||
| UP | Green/Blue Wire | |
| DOWN | Red/Blue Wire | |
| Main Switch/Passenger's | ||
| UP | Green/White Wire | |
| DOWN | White/Yellow Wire | |
| Main Switch/Left Rear | ||
| UP | Blue/White Wire | |
| DOWN | Yellow/White Wire | |
| Main Switch/Right Rear | ||
| UP | Green/Yellow Wire | |
| DOWN | White/Red Wire | |
POWER WINDOW SUB-SWITCH CIRCUIT TEST
| Switch Position | Wire Color | |
|---|---|---|
| Main Switch/Passenger's | ||
| UP | Green/White Wire | |
| DOWN | White/Yellow Wire | |
| Main Switch/Left Rear | ||
| UP | Blue/White Wire | |
| DOWN | Yellow/White Wire | |
| Main Switch/Right Rear | ||
| UP | Green/Yellow Wire | |
| DOWN | White/Red Wire | |
POWER WINDOW MAIN SWITCH-TO-MOTOR CIRCUIT TEST
| Switch Position | Wire Color | |
|---|---|---|
| Driver's Switch | ||
| UP | Green/Blue Wire | |
| DOWN | Red/Blue Wire | |
| Main Switch/Passenger's | ||
| UP | Red Wire | |
| DOWN | Green Wire | |
| Main Switch/Left Rear | ||
| UP | Red Wire | |
| DOWN | Blue Wire | |
| Main Switch/Right Rear | ||
| UP | White Wire | |
| DOWN | Yellow Wire | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.