Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1997 Mazda MPV ES, 3.0 2FACTORY OEM SERVICE PROCEDURE

Engine Controls - Specifications: Capacities

BATTERY SPECIFICATIONS

Application	Amp Hr. Rating
Standard	50
Heavy-Duty	65

FLUID CAPACITIESN

Application

Quantity Qts. (L)

Crankcase (Includes Filter)

5.1 (4.8)

Cooling System (Includes Heater)

1.3 (9.7)

Automatic Transmission ⁽²⁾

Oil Pan

4.2 (4.0)

Total

9.7 (8.9)

Front Differential ⁽³⁾

1.8 (1.7)

Rear Differential ⁽³⁾

1.6 (1.5)

Transfer Case ⁽¹⁾

1.6 (1.5)

⁽¹⁾	Use SAE 75W-90 for all-season conditions, and SAE 80W-90 for temperatures greater than 50°F (10°C).

⁽²⁾	Use M-III or Dexron-II ATF.

⁽³⁾	Use SAE 90 for temperatures greater than 0°F (-18°C), and SAE 80W for temperatures less than 0°F (-18°C).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.