1996 Mazda MPV DXFACTORY OEM SERVICE PROCEDURE

Section 40 (Engine Controls - Specifications): Capacities

WARNING: This page is about a different car, the 1995 Mazda 929. However, it is still accessible from the selected car via links, so may be relevant.
BATTERY SPECIFICATIONS

Application Amp Hr. Rating
Standard 48
Heavy-Duty 55
FLUID CAPACITIES

Application Quantity
Crankcase (Includes Filter) 5.3 Qts. (5.0L)
Cooling System (Includes Heater)
With Heater 9.9 Qts. (9.4L)
Without Heater 9.3 Qts. (8.8L)
Automatic Transmission (1) 9.1 Qts. (8.6L)
Rear Differential (2) 1.4 Qts. (1.3L)
(1) Use ATF M-III or Dexron-II.
(2) Use SAE 90 for temperatures greater than 0°F (-18°C), and SAE 80W for temperatures less than 0°F (-18°C).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.