Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Mazda MPV DXFACTORY OEM SERVICE PROCEDURE
Section 37 (Engine Controls - Specifications): Capacities
WARNING: This page is about a different car, the 1995 Mazda RX-7. However, it is still accessible from the selected car via links, so may be relevant.
BATTERY SPECIFICATIONS
| Application | Amp Hr. Rating |
|---|---|
| A/T | 52 |
| M/T | 43 |
FLUID CAPACITIES
| Application | Quantity | ||||||
|---|---|---|---|---|---|---|---|
| Crankcase (Includes Filter) | 4.0 Qts. (3.8L) | ||||||
| Cooling System (Includes Heater) | 9.2 Qts. (8.7L) | ||||||
| Manual Transmission (1) | 2.6 Qts. (2.5L) | ||||||
| Automatic Transmission (2) | 9.1 Qts. (8.6L) | ||||||
| Rear Differential (3) | 1.4 Qts. (1.3L) | ||||||
|
|||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
