Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Mazda MPV DXFACTORY OEM SERVICE PROCEDURE
Throttle Position (TP) Sensor Continuity: Inspection
- Turn ignition switch to OFF position and place throttle valve in closed throttle position. Disconnect TP sensor connector. Connect ohmmeter between terminals "C" and "D" of TP sensor connector. See Figure . Continuity should exist. If continuity exists, go to next step. If continuity does not exist, adjust TP sensor.
- Insert a feeler gauge of specified thickness between throttle lever & throttle stop screw. See TP SENSOR CONTINUITY TABLE . Connect ohmmeter between terminals "C" and "D" of TP sensor connector. See Figure . If continuity is not as specified, adjust TP sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.