1996 Mazda MPV DXFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS

Component Component Location
G1 (1995) At front of left front fender. See Figure .
G1 (1996) At front of left front fender. See Figure .
G2 (1995) At front of right front fender. See Figure .
G2 (1996) At front of right front fender. See Figure .
G3 (2.6L) (1995) At left side of engine.
G3 (3.0L) (1996) At left front of engine. See Figure .
G4 (2.6L) (1995) At left front of engine.
G4 (3.0L) (1996) At left front of engine. See Figure .
G5 (1996) At lower right center of dash.
G5 (3.0L) (1995) At left front of engine. See Figure .
G6 (3.0L) (1995) At left side of engine. See Figure .
G6 (3.0L) (1996) At lower left center of dash.
G7 (1995) At left end of dash.
G7 (1996) At lower left center of dash.
G8 (1995) At lower right center of dash.
G8 (1996) At left kick panel. See Figure .
G9 (1995) At left kick panel. See Figure .
G9 (1996) At right kick panel. See Figure .
G10 (1995) At left kick panel. See Figure .
G10 (1996) Below center console.
G11 (1995) At right kick panel. See Figure .
G11 (1996) Below center console.
G12 (1995) Below center console. See Figure .
G12 (1996) At left rear wheelwell.
G13 (1995) Below center console. See Figure .
G13 (1996) At left rear wheelwell.
G14 (1995) At right "D" pillar. See Figure .
G14 (1996) At center of liftgate.
G15 (1995) At right "D" pillar. See Figure .
G15 (1996) At right rear wheelwell.
G16 (1995) At right "D" pillar. See Figure .
G16 (1996) At right rear wheelwell.
G17 (1995) At lower left side of liftgate. See Figure .
G17 (1996) At left kick panel. See Figure .
G18 (1995) At upper right side of liftgate. See Figure .
G18 (1996) At right kick panel. See Figure .
G19 (1996) At right "D"pillar.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.