1995 Mazda Millenia BaseFACTORY OEM SERVICE PROCEDURE

Trouble Code Access

  1. Use New Generation Star (NGS) Tester (49 T088 0A0) to retrieve trouble codes. Connect NGS tester to data link connector-2. See Fig 1 . Refer to operation manual for proper operation of NGS tester. Select DIAGNOSTIC TROUBLE CODES function on tester and press trigger.
  2. Note trouble codes. Check TROUBLE CODE IDENTIFICATIONΒ  table for possible cause. If more than one code is present, codes will be displayed in numerical order. Clear codes after repairs are complete. See CLEARING CODESΒ  . If NO CODES RECEIVED/SYSTEM PASSED is displayed, all systems monitored are okay. If LINK MONITOR ERROR is displayed, check NGS tester connection for proper connection.
Fig 1: Locating Data Link Connector-2
G95G32280Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.