Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Mazda Millenia BaseFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| ABS Control Unit (1995) | Behind left side of dash. |
| ABS Control Module (1996) | Behind left side of dash. See Figure . |
| ABS Hydraulic Unit | On left rear of engine compartment. |
| ABS/TCS Control Unit (1995) | Behind left side of dash. |
| ABS/TCS Control Module (1996) | Behind left side of dash. See Figure . |
| Central Processing Unit (CPU) | On joint box. |
| Cruise Control Unit (1995) | Behind left side of dash. |
| Cruise Control Module (1996) | Behind left side of dash. See Figure . |
| Engine Control Module (ECM) | Under center of dash. See Figure . |
| Keyless Unit | Behind rear seat, on left side. See Figure . |
| Panel Lamp Control Box | Behind left side of dash, in back of instrument cluster. |
| Powertrain Control Module (PCM) (1996) | Under center of dash. See Figure . |
| SAS-Unit | Under center of dash. See Figure . |
| Solar Ventilation Control Unit (1995) | On left rear of luggage compartment. |
| Solar Ventilation Control Module (1996) | On left rear of luggage compartment. See Figure . |
| Transaxle Control Module (1996) | Behind left side of dash. See Figure . |
| Transmission Control Module (1995) | Behind left side of dash. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
