1995 Mazda MX-6 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS

Application Preferred Range
1995
Camber (1)
Front -0.60 -1.35 To 0.15
Rear -0.15 -0.90 To 0.60
Caster (1) 2.62 1.87 To 3.37
Toe-In (2)
Front 0.12 (3.0) 0 To 0.24 (0 To 6.0)
Rear 0.12 (3.0) 0 To 0.24 (0 To 6.0)
Toe-In (1)
Front 0.28 0 To 0.57
Rear 0.28 0 To 0.57
Toe-Out On Turns (1)
Inner 37 N/A
Outer 32 N/A
Steering Axis Inclination (SAI) (1) 15.07 N/A
1996 (3)
Camber (1)
Front -0.58 -1.58 To 0.42
Rear -0.1 -1.1 To 0.9
Caster (1) 2.52 1.52 To 3.52
Toe-In (2)
Front 0.16 (4.0) 0 To 0.32 (0 To 8.0)
Rear 0.12 (3.0) -0.04 To 0.28 (-1 To 7.0)
Toe-In (1)
Front 0.38 0 To 0.76
Rear 0.28 -0.1 To 0.67
Toe-Out On Turns (1)
Inner 37 N/A
Outer 32 N/A
Steering Axis Inclination (SAI) (1) 15.07 N/A
(1) Measurement in degrees.
(2) Measurement in inches (mm).
(3) Specifications listed are with fuel tank half full.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.