Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Mazda MX-3 AutomaticFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| ABS Control Module | Under passenger's seat. See Figure . |
| Central Processing Unit (CPU) | Behind left side of dash. |
| Cruise Control Module | Behind right kick panel. See Figure . |
| Daytime Running Lamp (DRL) Control Module | Behind right kick panel. See Figure . |
| Diagnostic Module (Air Bag) | Behind left side of dash. See Figure . |
| Engine Control Module (ECM) | Behind center of dash. See Figure . |
| Transaxle Control Module (TCM) | Behind center of dash. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.