Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Mazda MX-3 AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Brakeline Nuts | 10-16 (13-22) |
| Front Wheel Bearing Lock Nut | 174-235 (236-318) |
| Hydraulic Unit Mounting Nuts | 14-16 (19-22) |
| Rear Wheel Bearing Lock Nut | 131-173 (177-235) |
| Stabilizer Bar-To-Lower Control Arm Nut | 32-44 (43-60) |
| Tie Rod End-To-Steering Knuckle Nut | 32-41 (43-56) |
| Wheel Lug Nuts | 66-86 (89-117) |
| Wheel Speed Sensor Mounting Bolt | 14-18 (19-25) |
| INCH Lbs. (N.m) | |
| ABS Control Module Mounting Bolts/Nuts | 61-86 (6.9-9.8) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.