Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Mazda 929FACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Miscellaneous
MISCELLANEOUS
| Component | Component Location |
|---|---|
| A/C Amplifier | Under center of dash, forward of center console. |
| ABS Hydraulic Units | On right rear corner of engine compartment. See Figure . |
| Cold Start Injector | On top of engine. See Figure . |
| Condenser | On left front of engine compartment. See Figure . |
| Data Link Connector | Mounted on left front inner fender panel. See Figure . |
| Dropping Resistor | On right front corner of engine. |
| Ignition Coil | On left front side of engine compartment. See Figure . |
| Noise Filter | Behind left side of dash, to right of steering column. |
| Power Transistor (A/C-Heater) | Behind right side of dash, on blower housing. |
| Solar Cell | Above headliner, to left rear of sunroof opening. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
