CAUTION: DO NOT allow reservoir to run dry during brake bleeding procedure. If brake fluid is spilled, clean surface immediately with alcohol, as brake fluid will damage painted surfaces. Use only DOT 3 brake fluid and DO NOT mix with any other types.

Raise and support vehicle. Ensure brake fluid reservoir remains at least half full during bleeding procedure. When bleeding brake system, start with longest brakeline first. Remove bleed screw cap. Connect one end of transparent vinyl tube to bleed screw. Submerge other end of tube in a container half filled with clean brake fluid.
Have an assistant depress brake pedal several times and hold in depressed position. Loosen bleed screw and drain fluid into container. Tighten bleed screw.
NOTE: Ensure brake pedal remains depressed until bleed screw is tightened.
Refill brake fluid reservoir if necessary. Repeat step 2) until air is no longer discharged. Tighten bleed screw to 52-78 INCH lbs. (5.9-8.8 N.m). Ensure fluid leakage is not present. Add fluid to reservoir. Repeat procedure for remaining wheels.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Bleeding Brake System

Use the Manual With the Right Hardware

When to See a Mechanic