Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Mazda RX-7 AutomaticFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location | |
|---|---|---|
| ABS Control Unit | On left side of luggage compartment, behind trim panel. | |
| Central Processing Unit | ||
| CPU No. 1 | Behind fuse block, under left side of dash. | |
| CPU No. 2 | Behind left kick panel. | |
| Cruise Control Unit | Behind left kick panel. | |
| Electrical Load Control Unit | Behind right kick panel, above ECU. See Figure . | |
| Engine Control Unit (ECU) | Behind right kick panel. See Figure . | |
| Shift Lock Control Unit | Under console, forward of shift lever. | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
