Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Testing: Sub-Switch
Check continuity across specified terminals of sub-switch connector with main switch button held in specified position. See SUB-SWITCH CONTINUITY TEST . SeeFig 1 and Fig 2. Replace sub-switch if continuity is not as specified.
| Application & Sw. Position | Continuity Between Terminals | |
|---|---|---|
| Passenger | ||
| UP | A & F; B & D | |
| Off (Neutral) | B & D; E & F | |
| DOWN | A & B; E & F | |
| Rear | ||
| UP | A & E; B & D | |
| Off (Neutral) | A & C; B & D | |
| DOWN | A & C; B & E | |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.