Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Mazda MX-6 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Inspection (2.5L)
- Disconnect TP sensor connector. Connect ohmmeter between TP sensor connector terminals "E" and IDL. See Figure . Insert feeler gauge of specified thickness between throttle lever and throttle stop screw. See TP SENSOR CONTINUITY (2.5L) table.
- If continuity is not as specified, adjust TP sensor. See ADJUSTMENT procedure. If continuity is as specified, connect ohmmeter between TP sensor connector terminals Vt and "E". If resistance is less than 1000 ohms with throttle fully closed and about 5000 ohms with throttle wide open, TP sensor is adjusted. If resistance is not as specified, adjust TP sensor. See ADJUSTMENT procedure.
NOTE:
If ohmmeter reading indicates a rough transition anywhere in range between lowest and highest readings, TP sensor potentiometer is faulty. Replace TP sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
