1994 Mazda MX-6 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
ABS Control Unit Under right side of driver seat.
Air Bag Control Unit Behind left side of dash.
Central Processing Unit (CPU) Behind left kick panel.
Cruise Control Unit Behind left side of dash, near steering column.
DRL Control Unit (Canada) Behind left side of dash, near fuse block.
Engine Control Unit (ECU) Under center of dash. See Figure .
Stop/Taillight Check Module (MX-6) On left side of luggage compartment.
Stop/Taillight Check Module (626) On right side of luggage compartment.
Transmission Control Module Under center of dash.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.