Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1994 Mazda MX-3 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS

Application

Preferred

Range

Camber ⁽¹⁾

Front

-0.80

-1.55 To -0.05

Rear

-0.92

-1.67 To -0.17

Caster ⁽¹⁾

2.63

1.88 To 3.38

Toe-In ⁽²⁾

Front

0.12 (3.0)

0 To 0.24 (0 To 6.0)

Rear

0.08 (2.0)

-0.04 To 0.2 (-1.0 To 5.0)

Toe-In ⁽¹⁾

Front

0.30

0 To 0.60

Rear

0.20

-0.10 To 0.50

Toe-Out On Turns ⁽¹⁾

Inner

N/A

Outer

N/A

Steering Axis Inclination (SAI) ⁽¹⁾

13.75

N/A

⁽¹⁾	Measurement in degrees.

⁽²⁾	Measurement in inches (mm).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.