Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Mazda MX-3 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Trouble Code Identification Table
TROUBLE CODE IDENTIFICATION
| DTC | Description |
|---|---|
| CODE 2 | NE2 Signal - Distributor) |
| CODE 3 | G Signal - Distributor) |
| CODE 4 | NE1 Signal - Distributor) |
| CODE 5 | Knock Sensor) |
| CODE 8 | Airflow Meter) |
| CODE 9 | Coolant Thermosensor) |
| CODE 10 | Intake Air Thermosensor) |
| CODE 12 | Throttle Sensor) |
| CODE 14 | Atmospheric Pressure Sensor) |
| CODE 15 | Heated Oxygen Sensor) |
| CODE 16 | EGR Position Sensor) |
| CODE 17 | Feedback System) |
| CODE 23 | Heated Oxygen Sensor) |
| CODE 24 | Feedback System) |
| CODE 25 | Pressure Regulator Solenoid Valve) |
| CODE 26 | Purge Control Solenoid Valve) |
| CODE 28 | EGR Vacuum Valve Solenoid) |
| CODE 29 | EGR Vent Valve Solenoid) |
| CODE 34 | Idle Speed Control) |
| CODE 41 | Variable Inertia Charging Sys Sol 1) |
| CODE 46 | Variable Inertia Charging System Sol 2) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.