1994 Mazda MX-3 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Throttle Position (TP) Sensor: Adjustment

  1. Disconnect TP sensor connector. Connect ohmmeter between TP sensor connector terminals "E" and IDL. See Fig 1 . Loosen TP sensor attaching screws.
  2. Insert a .006" (.15 mm) feeler gauge (MX-3 1.8L) or .010" (.25 mm) feeler gauge (all other models) between throttle lever and throttle stop screw. Rotate TP sensor clockwise about 30 degrees, then rotate counterclockwise until ohmmeter indicates continuity.
  3. Remove feeler gauge. Insert a .020" (.50 mm) feeler gauge (MX-3 1.8L) or .016" (.40 mm) feeler gauge (all other models) between throttle lever and throttle stop screw. If ohmmeter indicates no continuity, go to next step. If ohmmeter indicates continuity, repeat adjustment procedure.
  4. Tighten TP sensor attaching screws. Open throttle valve fully and verify resistance between terminals "E" and Vt is about 5000 ohms.
NOTE: TP sensor on MX-6 2.0L and 626 2.0L is not adjustable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.