Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
KOEO Self-Test
Ensure engine is at normal operating temperature. If engine does not start (or stalls after starting), continue KOEO SELF-TEST. Perform the following step(s) as applicable:
- DO NOT depress throttle.
- On vehicles with Brake On-Off (BOO) circuit, apply and release brake pedal after vehicle ID code is given.
- On vehicles with Power Steering Pressure (PSP) switch, turn steering wheel 1/2 turn and release after vehicle ID code is given.
- On vehicles with Transmission Control Switch (TCS), cycle TCS after vehicle ID code is given.
Turn ignition off. Wait 10 seconds. Ensure test equipment is properly attached. Turn ignition on (engine off). Record all KOEO codes and Continuous Memory Codes.
- If PCM will not output codes, go to CIRCUIT TEST QA.
- If codes are outputted, repair codes in the order displayed. See SERVICE CODE REFERENCE.
- If vehicle has a no-start condition, go to CIRCUIT TEST AA (3.0L), CIRCUIT TEST AB (2.3L).
- If vehicle displays Code 111 (pass code), go to KOER SELF-TEST.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
