Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Mazda MX-3 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System
- Description
- Operation
- Anti-Lock Brake Safety Precautions
- Bleeding Brake System
- Trouble Shooting
- Diagnosis & Testing
- Diagnostic System Description
- Retrieving Trouble Codes
- Erasing Trouble Codes
- System Testing
- Notes
- ABS-1 - Codes 11, 12, 13 & 14 (Wheel Speed Sensor, Wiring Harness, Sensor Rotor & Hydraulic Pressure)
- ABS-2 - Code 15 (Wheel Speed Sensor & Wiring Harness)
- ABS-3 - Code 22 (Hydraulic Unit, Solenoid Valve & Wiring Harness)
- ABS-4 - Code 51 (Fail-Safe Relay)
- ABS-5 - Code 53 (Motor & Motor Relay)
- ABS-6 - Code 61 (ABS Control Unit)
- Component Testing
- ABS Warning Light
- Wheel Speed Sensor (Inspection)
- Wheel Speed Sensor (Resistance Test)
- Wheel Speed Sensor (Voltage Test)
- Sensor Rotor
- Stoplight Switch
- Stoplight Switch (Harness Test)
- ABS Control Unit
- Hydraulic System Test
- Hydraulic Unit (Motor Test)
- Hydraulic Unit (Motor Harness Resistance Test)
- Hydraulic Unit (Solenoid Valve Test)
- Hydraulic Unit (Solenoid Valve Harness Resistance Test)
- Relay Box (Fail-Safe Relay Harness Test)
- Relay Box (Fail-Safe Relay Resistance Test)
- Relay Box (Motor Relay Harness Test)
- Relay Box (Motor Relay Resistance Test)
- Removal & Installation
- Adjustments
- Torque Specifications
- Wiring Diagram
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
