Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Mazda MX-3 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Component Locations
NOTE:
For more information on fuses and circuit breakers, see FUSES & CIRCUIT BREAKERS
.
COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Joint Box (Interior Fuse Panel) | Behind Left Side Of Instrument Panel |
| Main Fuse Box | Engine Compartment Left Fender |
| Power Window Master Control Switch | Driver's Door Armrest |
| Power Window Motor | Inside Respective Door |
| Passenger Power Window Switch | Passenger Door Armrest |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.