1992 Mazda MPV LXFACTORY OEM SERVICE PROCEDURE

Engine Control Unit (Except NAVAJO)

  1. Locate Engine Control Unit (ECU). See ECU LOCATIONΒ  table. Connect Engine Signal Monitor (49-9200-162) to ECU. See Fig 1 . Check voltage at each terminal of ECU. If input and output component voltage readings are not as specified, check faulty component. See PIN VOLTAGE CHART S article, TESTS W/CODES - EXCEPT NAVAJO article and testing for appropriate component in this article.
  2. If input and output component voltages are as specified, and ECU voltage is incorrect, replace ECU.
CAUTION: DO NOT apply voltage to terminals "A" and "B" of engine signal monitor. See Fig 1 .
ECU LOCATION

Application Location
B2200, B2600i & 929 Behind Passenger Front Side Trim Panel
Miata & MPV Under Passenger Front Floor Mat
MX-3, Protege & 323 Behind Driver & Passenger Front Side Walls
MX-6 & 626 Behind Passenger Side Console Cover
Fig 1: Testing Engine Control Unit ECU
G92B24985Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.