Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Mazda MPV LXFACTORY OEM SERVICE PROCEDURE
Circuit Protection Devices
CIRCUIT PROTECTION DEVICES LOCATION
| Component | Location | |
|---|---|---|
| Fuse Block | Behind left side of dash. | |
| Main Fuse Block | ||
| Engine Compartment (2.6L) | On right rear of right engine compartment, on inner fender panel. See Figure . | |
| Engine Compartment (3.0L) | On right rear of right engine compartment, on inner fender panel. See Figure . | |
| Relay Block | ||
| Engine Compartment (2.6L) | On left side of engine compartment, on inner fender panel. See Figure . | |
| Engine Compartment (3.0L) | On left side of engine compartment, on inner fender panel. See Figure . | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.