1991 Mazda 929 BaseFACTORY OEM SERVICE PROCEDURE

Airflow Meter/Sensor: Inspection

Inspect airflow meter for damage and ensure measuring plate moves smoothly. See Fig 1 . Disconnect airflow meter connector. Move measuring plate and measure resistance between terminals. See AIRFLOW METER TERMINAL RESISTANCE  table.

AIRFLOW METER TERMINAL RESISTANCE

Terminals Fully Closed Ohms Fully Open Ohms
E2-Vs 20-400 20-1000
E2-Vc (1) 100-300 (1) 100-300
E2-Vb 200-400 200-400
E2-THA (2) 13,600-18,400 (2) 13,600-18,400
(3) 2200-2700 (3) 2200-2700
(4) 500-700 (4) 500-700
E1-Fc Infinite 0
(1) 100-400 ohms on MX-6 and 626.
(2) Tested at -4°F (-20°C).
(3) Tested at 68°F (20°C).
(4) Tested at 140°F (60°C).
Fig 1: Airflow Meter & Connector
G117768Courtesy of MAZDA MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.