Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
A/C Cut-Out Control System (Except SOHC)
1991 Mazda 929 BaseSECTION A/C Cut-Out Control System (Except SOHC)
- Turn A/C, blower and ignition switches on. DO NOT start engine. Shift transmission into a drive gear. Open throttle fully. Listen for A/C clutch disengaging and re-engaging after a few seconds. See A/C CUTOUT TIME SPECIFICATIONS.
- If system does not perform as specified, check operations of related switches and relays. See PIN VOLTAGE CHART S and SENSOR RANGE CHARTS articles.
A/C CUT-OUT TIME SPECIFICATIONS
| Application | Time Before Re-engagement |
|---|---|
| 929 (DOHC) | 5 Seconds |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.