Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Check VRS Resistance (NAVAJO)
Turn key off and disconnect ECA. Connect EDIS diagnostic cable negative lead to negative battery terminal. Set DVOM to 20-k/ohm scale. Measure resistance between breakout box pins No. J48 (VRS E) and J35 (VRS+ E). If resistance is 2580-2700 ohms, go to VRS SENSOR (NAVAJO). If resistance is not 2580-2700 ohms, repair wires between VRS and EDIS or replace VRS.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.