Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Mazda RX-7 Base, StandardFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| Anti-Lock Brake (ABS) Control Unit | Under dash, on right side. See Figure . |
| Automatic Adjusting Suspension (AAS) Control Unit | In rear of vehicle, to right of license plate. |
| Central Processing Unit (CPU) | Behind left front kick panel. See Figure . |
| Cruise Control Unit | Under left side of dash, near CPU. See Figure . |
| Door Lock Control Unit | In CPU, behind left kick panel. |
| Engine Control Unit (ECU) | Below right side of dash. See Figure . |
| Power Steering Control Unit | Under steering column. See Figure . |
| Theft Deterrent Control Unit | Below right side of dash, behind glove box. See Figure . |
| Electronic Transmission Control Unit | Behind right kick panel. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
