1990 Mazda RX-7 Base, StandardFACTORY OEM SERVICE PROCEDURE

Coolant THERMOVALVE

  1. Remove coolant thermovalve from throttle body. Place coolant thermovalve in container of water.
  2. Heat water gradually and note temperature at which air will pass through proper port location of valve. See COOLANT THERMOVALVE SPECIFICATIONS  table. Temperature of air passage must be within specification.
COOLANT THERMOVALVE SPECIFICATIONS

Application Air Passage Through Valve Ports
Non-Turbo
A/T
Greater Than 154°F (68°C) Center To Bottom
Less Than 154°F (68°C) Center To Top
M/T
Greater Than 171°F (77°C) (1)
Less Than 171°F (77°C) Top To Bottom
Turbo
Greater Than 140°F (60°C) (1)
Less Than 140°F (60°C) Top To Bottom
(1) From top port out through top center area of valve.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.