Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Mazda RX-7 Base, StandardFACTORY OEM SERVICE PROCEDURE
Resistor Relay (RX7 Only)
- Remove air cleaner and airflow meter. Disconnect fuel pump resistor. Ensure continuity exists between terminals "a" and "b". See Fig 1 and Fig 2 .
- Measure resistance between the following terminals. Resistance between terminals "c" and "d" should be 60-92 ohms and between "e" and "f" should be .70-.94 ohms. If resistor relay does not test as specified, replace relay.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.