Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Mazda 626 BaseFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Miscellaneous
MISCELLANEOUS LOCATION
| Component | Location | |
|---|---|---|
| A/C-Heater Blower Motor Resistor | On blower housing. See Figure . | |
| Automatic Adjusting Suspension (AAS) Actuator | On top of each shock tower. | |
| Check Connectors | ||
| Anti-Lock Brakes (ABS) | Under driver's seat. | |
| Auto Adjusting Suspension (AAS) | In left rear corner of engine compartment. | |
| Electronic Transaxle | On left side of dash, near kick panel. See Figure . | |
| Engine Control | At engine control unit connector terminal. | |
| Power Steering | In left rear corner of engine compartment. | |
| Electronic Transaxle Pulse Generators | On top of transaxle. See Figure . | |
| Electronic Transaxle Resistor | Near left side of radiator. See Figure . | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.