Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Mazda RX-7 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Boost Pressure
- Disconnect air hose between intercooler and solenoid valve. Connect pressure gauge. See Fig 1 . Plug duty solenoid side of hose. Warm engine to normal operating temperature.
- Measure boost pressure while suddenly increasing engine speed. At approximately 4000 RPM boost should begin. Above approximately 5000 RPM pressure should be more than .07 psi (0.049 kg/cm2 ). If boost pressure is not within specification, proceed to following tests as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.