1989 Mazda RX-7 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Sub-Zero Starting Assist

  1. Ensure fluid supply tank contains adequate amount of fluid. Disconnect "S" terminal connector from starter motor. Remove starting fluid valve from intake manifold.
  2. Turn ignition switch to "START" position. Note that no fluid is sprayed from valve with ambient temperature above -4Β°F (-20Β°C). Disconnect connector from oil thermo unit located on the oil pan.
  3. Touch connector to ground. Turn ignition switch to "START" position. Push air bleed button on air tank. Check that fluid is sprayed from the valve. If fluid is sprayed, check oil thermo unit.
  4. Using ohmmeter, check for continuity at oil thermo unit terminals. Replace thermo unit if continuity did not exist at specified temperature. See OIL THERMO UNIT CONTINUITYΒ  table.
OIL THERMO UNIT CONTINUITY

Temperature Continuity
Above 3.2Β°F (-16Β°C) No
Below 3.2Β°F (-16Β°C) Yes
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.