Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Mazda RX-7 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Injector Fuel Leakage
- Remove dynamic chamber, if necessary. Loosen delivery pipe attaching bolts. Remove delivery pipe. Using wire, secure injectors tightly onto delivery pipe.CAUTION: Ensure injectors are securely tied to delivery pipe. If not properly secured, fuel may spray from loose connections.
- Install jumper wire between 2 terminals of fuel pump test circuit connector. See BASIC TESTING for test connector location. Turn ignition on. Check that no fuel leakage exists at injectors. After 5 minutes, only a slight amount of fuel leakage is acceptable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
