Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Mazda MX-6 4WSFACTORY OEM SERVICE PROCEDURE
Fuel Pressure
- On all 4-Cyl moddels, disconnect circuit opening relay (located behind left kick panel on B2600i and 323, on panel near clutch pedal on MX-6 and 626). On MPV, relay is mounted on ECU. ECU is under protective cover on passenger side floor. Start engine (if possible) and allow to die. Connect pressure gauge to fuel line at fuel filter.
- Turn ignition on. Using a jumper wire, connect terminals of Yellow fuel pump check connector together. Fuel pump check connector is located on firewall, near windshield wiper motor on B2600i, MX-6, 323 and 626, and near airflow sensor on MPV. If pump runs, check fuel pump circuit and circuit opening relay.
- If possible, start engine. Check fuel pressure with vacuum connected to and disconnected from pressure regulator. Turn engine off and disconnect jumper wire at fuel pump check connector. Wait 10 minutes and ensure residual pressure is at least 21 psi (1.5 kg/cm2 ).
- Operate fuel pump by jumpering fuel pump test connector. Check fuel pump performance. Pinch hose between pressure gauge and fuel filter. Do not hold longer than necessary to check pressure. See FUEL PUMP PERFORMANCE table. If pump does not meet specifications, check fuel pump circuits, fuel pump, fuel tank, fuel filter or replace fuel pump.
FUEL PUMP PERFORMANCE
| Application | Pressure psi (kg/cm2 ) | Min. Vol. in 30 sec. Pts. (L) | ||||
|---|---|---|---|---|---|---|
| B2600i, MPV, MX-6 (1) , 323 (2) , 626 (1) | 64-85 (4.5-6.0) | 1.1 (.66) | ||||
|
||||||
REGULATED FUEL PRESSURE - AT IDLE
| Application | w/Vacuum psi (kg/cm2 ) | w/o Vacuum psi (kg/cm2 ) |
|---|---|---|
| B2600i, MPV & | 31-38 (2.2-2.7) | 38-46 (2.7-3.2) |
| MX-6 & 626 | 27-33 (1.9-2.3) | 34-40 (2.4-2.8) |
| 323 | 26-31 (1.8-2.2) | 34-40 (2.4-2.8) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
