1989 Mazda 929FACTORY OEM SERVICE PROCEDURE

Function Test

  1. To trouble shoot 929 models refer to trouble shooting chart. See Figure . Actuators on turbocharged models can be tested with an ohmmeter only. When checking actuator on models with automatic transmission, the ACC tester MUST be modified to avoid damage to the Overdrive control unit.
  2. To modify tester, cut wire at terminal No. 6 of ACC tester connector and tape the end. See Figure .
  3. The main switch, actuator-VAC, actuator-VENT 2, actuator-VENT 1, clutch/brake switch, combination/inhibitor switch (automatic transaxle models), and generator operation are verified by lights on tester. Tester has a check switch and a slide switch.
  4. Check switch tests actuator operation with engine running. When switch is held in the "ON" position with engine running, engine speed is increased to and held at 2000-3000 RPM. If RPM does not increase, ensure actuator cable freeplay is correct. Slide switch should be in the "L" position. Follow test chart for ACC tester. See Fig 1 .
NOTE: When installing ACC tester, turn ignition and main switch off. When performing all testing steps, main and ignition switches must be in "ON" position. Signal generator light can be either "ON" or "OFF" during testing.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.